HOME
CONTACT US
BECOME A DEALER
PRODUCTS
GRIPONE 2
GRIPONE PRO 2
GRIPONE MX
GRIPONE MOTARD
ACCESSORIES
REMOTE CONTROL STANDARD
REMOTE CONTROL ANALOGUE
SPEED SENSOR
BANKING ANGLE SENSOR
DOCUMENTS
USER MANUALS
SOFTWARE GRIPONE PRO 2
BROCHURE
STORE
PRODUCTs
YOUR CHART
CUSTOMER AREA
GRIPONE is a trademark of |
GRIPONE MOTARD - TRACTION CONTROL SYSTEM
What's GRIPONE MOTARD In motorsport, in every movement bike is in critical situations in which the rear wheel loses grip under acceleration. GRIPONE MOTARD is a universal device, designed to be easily connected to any vehicle and through which you can control the level of rear wheel slip GRIPONE MOTARD si può installare su tutti i modelli di moto ad iniezione elettronica. Inoltre sono disponibili kit plug & play comprensivi di connettori originali per eseguire l'installazione senza modificare l'impianto originale. Honda CRF450 (tutte quelle a iniezione) How it works GRIPONE MOTARD is a electronic traction control system that consists of two devices: the control unit GRIPONE and two speed sensors. These, working in unison, check the conditions of rear grip of the motorcycle. Whenit's normal the unit is not active. When slip is detected above normal, the control unit reduce engine power until the spinning is restored. Once the rear tire grip come back to normal the control unit stop to reduce the engine power. Features 1. Adjusting device. The settings of the five parameters that control the operation of the controller (SPINNING, CUT, ENGINE, RATIO, PULSE) is via two simple buttons and LEDs positioned on the front panel. 2. The consumption of electric current are very low: on average less than 50mA in standby mode. 3. Total customization possibilities. With GRIPone you can separately adjust the sensitivity to spinning ratio and the intensity of the control on the power of the vehicle. 4. New algorithm MTC. The Multi Thresould Control allows you to anticipate the opening of the gas because at first slip of rear tyre the unit start to control very smoothly. When Slip ratio gradually increases the dynamic threshold algorithm increase power control. 5. Variation of sensitivity remotely. On to the unit there is an additional connector for connecting the accessory "remote control" through which you can change the mapping without stopping the vehicle. 6. Alarm Spinning. The accessory remote control lets you to select between two maps and it provides an LED indicator to advice the start of working of traction control. 7. Spinning meter. The LEDs on the front of GRIPONE MOTARD, informs the rider on the level of spin ratio. A LED bar switch on according to the level of rear wheel slipping. 8. Diagnostic. In case of problem to one (or each) of speed sensor the new GRIPONE 2 advice the user by a lamp of leds (on the ecu) and by the led of remote control. 9. Advanced parameters . GRIPONE MOTARD Gives to the user the ability to set 2 more parameters to get a very fine tuning of system. The first parameter set the dependence of sensitive by the veichle speed. By this parameter the ECU give a strong support in slow corner and stability in fast corner. The second parameter set the type of remote control connected to the ECU. GRIPONE MOTARD kit include the ECU, 2 wheel sensors with cable, a plug & play harness (available for Honda, Yamaha, Suzuki, Kawasaki, KTM, Ducati, Aprilia e Triumph) and the user manual. Dimension Weight: about 300g
|
